If faults are present, the gauge cluster display will show each diagnostic trouble code for 10 seconds and then automatically scroll to the next entry and continue to cycle through the faults. NOTE – The gauge cluster will only display “Software Rev” and “Hardware Rev” for 5 seconds followed by the message “Diagnostic Trouble Codes are not available” if the vehicle is not equipped with the option to display codes. The gauge cluster will then display the following information for 5 seconds: Momentarily press the Cruise “ON” switch and the Cruise “Resume” switch at the same time.Ī gauge sweep will be performed on the gauges.Turn the key switch to the IGNITION position to view both active and previously active codes. Turn the key switch to the ACCESSORY position to view only previously active codes. To display codes on vehicles not equipped with a VID: VEHICLES EQUIPPED WITH OPTION TO DISPLAY CODES Displaying Codes on the Gauge Cluster (Non-VID equipped vehicles)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |